Assignment completed???

Well, for the time being, we have done our report and basically done all the things required. So, it seems like things run smoothly.

May be this our last post and tomorrow will be time for our circuit presentation.

Circuit testing completed!!!

So far, the circuit has successfully built into copper board and work as expected.

So we have done the part on circuit testing. Compare to other group, our circuit is much easier because no need to see the result from oscilloscope.

We have used an LED with voltage supplied connected to relay of the circuit. When the relay is turned on, LED lights on and vice versa.

The circuit turn on LED when there is low light frequency.

Now, we left the report part and powerpoint presentation to be done.

Circuit testing

Today we have build the circuit on the copper board and finished up the pattery the circuit. Then we tested the circuit and it works as expected.

We use a LED to test the circuit works or not, when there is no light, the circuit is triggered and turn on the switch which subsequently turn on the LED. When there is light shine on LDR, the circuit is not triggered and the switch is turned off and LED is off.

Update on our analog project

So far,

We have tried to build our circuit in breadboard and it's working!!!

Thus, we progress to build the circuit with copper board. And as for our report, we almost finish it.

So, we left about testing our circuit, and see the output, hope it will works!